Bizon Glass Watch Hydrogel Redmi Watch 3 Active [2 PACK] (zegarek)

Bizon Quality

The hydrogel film Bizon Glass Watch Hydrogel is made of flexible, thermoplastic polyurethane. The product is suitable for protecting the smartwatch screen from scratches and dirt. The film is created using modern technologies such as Self Heal — which supports self-regeneration in case of minor scratches or air bubbles that disappear over time.

Film Dimensions

Film dimensions: 4.29 x 3.59 x 4.83 cm

When choosing a case, make sure that the film is smaller than the inner dimensions of the case.

Note! Depending on the device model, Bizon Glass Watch Hydrogel may not be compatible with cases.

Product Functionality

The film features high transparency and maintained screen sensitivity. An additional advantage is the coverage of almost the entire display with minimal margin. Bizon Glass Watch Hydrogel is only 0.15 cm thick, making it thinner than tempered glass.

Package Contents

• film Bizon Glass Hydrogel – 2 pieces
• positioning stickers – 3 pieces
• application support card - 1 piece
• dry microfiber cloth – 1 piece
• wet screen cleaning cloth – 2 pieces
• round sticker for picking up dust and debris (dust absorber) – 1 piece

Installation Instructions

1. Make sure the film is dedicated to the model of the smartwatch you own.
2. Clean the screen with the wet cloth and microfiber.
3. Examine the product carefully, paying attention to the layers: matte white backing, positioning film, actual film, and outer protective layer.
4. Remove the middle protective part of the positioning film, marked with number 1, and then rotate the film along the vertical edge.
5. Ensure the film is oriented correctly and stick the middle part of the film to the screen – if it sticks crookedly, it can be peeled off and reapplied. This action aims to position the film correctly; it is not the actual film.
6. Lift and gently bend the shorter, lower part of the matte backing with the Bizon inscription so that it peels away from the film, and using the card, in one smooth motion, slide towards the bottom edge of the screen so that the film adheres properly.
7. Repeat the same action with the second, longer part of the film, remembering to peel it away from the matte white backing. Slide the card across the screen to remove any remaining air bubbles. Any dust particles can be removed using the round sticker (dust absorber).
8. At the top of the screen, you will find a protruding end, grab it and thus remove the remaining protective layer. Done!

If air bubbles appear, they can be gently pushed outwards. Please note that small bubbles will disappear within 24 hours.