Bizon Glass Watch Hydrogel Xiaomi Watch S3 47 mm [2 PACK]

Quality of Bizon

The hydrogel film Bizon Glass Watch Hydrogel is made of flexible, thermoplastic polyurethane. The product is suitable for protecting the smartwatch screen from scratches and dirt. The film is created using modern technologies such as Self Heal — which supports self-regeneration in case of minor scratches or air bubbles that disappear over time.

Dimensions of the film

Dimensions of the film: 3.70 cm

When choosing a case, make sure that the film is smaller than the internal dimensions of the case.

Note! Depending on the device model, Bizon Glass Watch Hydrogel may not be compatible with cases.

Product functionality

The film features high transparency and maintained screen sensitivity. An additional advantage is the coverage of almost the entire display with minimal margins. Bizon Glass Watch Hydrogel is only 0.15 cm thick, making it thinner than tempered glass.

Package contents

• film Bizon Glass Hydrogel – 2 pieces
• positioning stickers – 3 pieces
• application support card - 1 piece
• dry microfiber cloth – 1 piece
• wet cloth for screen cleaning – 2 pieces
• round sticker for picking up dust and debris (dust absorber) – 1 piece

Installation instructions

1. Make sure that the film is dedicated to the model of smartwatch you own.
2. Clean the screen with the wet cloth and microfiber.
3. Carefully examine the product, paying attention to the layers: matte white backing, positioning film, actual film, and outer protective layer.
4. Remove the central protective part of the positioning film, marked with number 1, and then rotate the film along the vertical edge.
5. Ensure that the film is aligned in the correct direction and stick the central part of the film to the screen – if it is applied crookedly, it can be peeled off and reapplied. This action aims to properly position the film; it is not the actual film.
6. Lift and gently bend the shorter, lower part of the matte backing with the Bizon inscription so that it separates from the film and, using the card in one smooth motion, swipe towards the bottom edge of the screen so that the film adheres properly.
7. Perform the same action with the second, longer part of the film, remembering to peel it off from the matte, white backing. Slide the card across the screen to remove any remaining air bubbles. You can remove any dust particles using the round sticker (dust absorber).
8. At the top of the screen, you will find a protruding end, grab it and in this way, remove the remaining protective layer. Done!

If air bubbles appear, you can gently push them outwards. Please note that small bubbles will disappear within 24 hours.