Quality of Bizon
The hydrogel film Bizon Glass Hydrogel Front is made of flexible, thermoplastic polyurethane. The product is suitable for protecting the phone screen from scratches and dirt. The film is created using modern technologies such as Self Heal — which supports self-regeneration in case of minor scratches or air bubbles that disappear over time.
Dimensions of the film
When choosing a case, make sure that the film is smaller than the internal dimensions of the case.
Dimensions of the film: 15.65 x 7.06 x 16.70 cm
Note! Depending on the model of the device, Bizon Glass Hydrogel Front may not be compatible with cases.
Product functionality
The film features high transparency and maintained screen sensitivity. An additional advantage is coverage of almost the entire display with a minimal margin. Bizon Glass Hydrogel is only 0.15 mm thick, making it thinner than tempered glasses.
Contents of the set
- film Bizon Glass Hydrogel Front – 2 pieces
- positioning stickers – 3 pieces
- application support card - 1 piece
- dry microfiber cloth – 1 piece
- wet cloth for cleaning the screen – 2 pieces
- round sticker for picking up dust and debris (dust absorber) – 1 piece
Installation instructions
- Make sure the film is dedicated to the model of the phone you have.
- Clean the screen with the wet cloth and microfiber.
- Carefully examine the product, paying attention to the layers: the matte white base, positioning film, the actual film, and the outer protective layer.
- Remove the middle protective part of the positioning film, marked with number 1, and then turn the film along the vertical edge.
- Make sure the film is oriented correctly and stick the middle part of the film to the screen – if it is stuck crookedly, it can be peeled off and reapplied. This action is aimed at properly positioning the film; it is not the actual film.
- Lift and gently bend the shorter, lower part of the matte base with the word Bizon so that it peels off from the film, and with the card, make a smooth motion towards the bottom edge of the screen so that the film adheres properly.
- Perform the same action with the second, longer part of the film, remembering to peel it off from the matte white base. Slide the card across the screen to remove any remaining air bubbles. Any dust particles can be removed with the round sticker (dust absorber).
- At the top of the screen, you will find a protruding tip, grab it and in this way, remove the remaining protective layer. For phones with a rounded screen, remember to press the edges of the film only at the very end, after removing the protective layer. Done!
If air bubbles appear, they can be gently pushed outwards. Keep in mind that small bubbles will disappear within 24 hours.
Data sheet
Type | protective film |
---|---|
Number of pieces in the set | 2 |
Specific References
EAN13 | 5904665399606 |
---|---|
MPN | BGHS2NP2 |