Quality of Bizon
The hydrogel film Bizon Glass Hydrogel Front is made of flexible, thermoplastic polyurethane. This product is suitable for protecting the phone screen from scratches and dirt. The film is created using modern technologies, such as Self Heal — which aids in self-regeneration in case of minor scratches or bubbles that disappear over time.
Film Dimensions
When selecting a case, make sure that the film is smaller than the internal dimensions of the case.
Film dimensions: 15.49 x 7 cm
Note! Depending on the model of the device, Bizon Glass Hydrogel Front may not be compatible with cases.
Product Functionality
The film features high transparency and maintains screen sensitivity. An additional advantage is the coverage of almost the entire display with minimal margin. Bizon Glass Hydrogel is only 0.15 mm thick, making it thinner than tempered glass.
Package Contents
- film Bizon Glass Hydrogel Front – 2 pieces
- positioning stickers – 3 pieces
- application support card - 1 piece
- dry microfiber cloth – 1 piece
- wet cloth for screen cleaning – 2 pieces
- round sticker for picking up dust and particles (dust absorber) – 1 piece
Installation Instructions
- Make sure the film is dedicated to the model of the phone you have.
- Clean the screen with a wet cloth and microfiber cloth.
- Carefully examine the product, paying attention to the layers: matte white backing, positioning film, actual film, and outer protective layer.
- Remove the middle protective part of the positioning film, marked with number 1, and then turn the film along the vertical edge.
- Make sure the film is aligned correctly and stick the middle part of the film to the screen – if it is applied crookedly, it can be peeled off and reapplied. This step is intended for properly positioning the film; it is not the actual film.
- Lift and gently bend the shorter, lower part of the matte backing with the Bizon label so that it separates from the film and use the card to smoothly slide toward the bottom edge of the screen, ensuring the film adheres properly.
- Repeat the same action with the longer part of the film, remembering to peel it off the matte white backing. Slide the card over the screen to remove any remaining air bubbles. You can remove any dust particles using the round sticker (dust absorber).
- At the top of the screen, you will find a protruding end, grab it and remove the remaining protective layer. For phones with a rounded screen, remember to press down the edges of the film only at the very end, after removing the protective layer. Done!
If air bubbles appear, you can gently push them outwards. Please note that small bubbles will disappear within 24 hours.
Data sheet
Type | protective film |
---|---|
Number of pieces in the set | 2 |
Specific References
EAN13 | 5903896182513 |
---|---|
MPN | BGHS2RN10/S |